View Cluster Issue

[Former Member]

Hi all,

I have created a View Cluster for two custom tables. i.e Header and Item

Both the tables are customzing tables .

Cluster is created suceesfully.

Now client requirement is like... i have a status field in both the tables.

Depending on some condition i am updating status in header , now if there are some item record for that header then item status should also change according to header status.

So basically how to pass status value from header to item and item to header....

Please help !!

thanks in advance

Regards,

Harsharandeep

[former_member191735]

>

>

> So basically how to pass status value from header to item and item to header....

>

Go to View cluster (SE54) - Go to item field dependence - in the table control I think it is the last field called type (where you assign predesses) - Choose 'I' which is copy initial subset field selection conditions - i think this will solve your problem

or

If you define predesses which is item-field = header-field

You cannot copy back to Header from item (as far as i know)

Good luck

[Former Member]

Hi ,

In both table status field is different..

product_status in header and

variant_status in item table.

if i change header record product_status will change and i press save.. how will variant_status for item record will set to same status of that header record.

Please reply,.

Regards,

Harsharandeep Singh

[Former Member]

This message was moderated.

[Sandra_Rossi]

As everyone knows (forum rules), you MUST give feedback. Abuse reported to moderators.