Table Control with wizard

[Former Member]

Hi all,

My requirement is to update the custom table thru table control, so i have used table control with wizard,i have written the code for saving the entry and i have set the PF Status also, but however when iam debugging iam not getting SY-UCOMM,its blank.....how can i handle this?

Helpful answers will be rewarded.......

[Former Member]

Hi all,

My requirement is to update the custom table thru table control, so i have used table control with wizard,i have written the code for saving the entry and i have set the PF Status also, but however when iam debugging iam not getting SY-UCOMM,its blank.....how can i handle this?

Helpful answers will be rewarded.......

[Former Member]

the thing is sy-ucomm gets cleared sometimes...so what u should do is declare a variable and when u press SAVE....assign sy-ucomm to this variable and u can use this variable at any point...

[Former Member]

Yeah i declared a variable also.....

but its getting cleared....

[Former Member]

Use the Standard Variable for Okcode.

[Sandeep_Panghal]

Hi,

Try with ok_code = FCODE and clear ok_code after processing.

[Former Member]

Hi

if you are using the table control wizars then sy-ucomm would be available in ok_code

so use

case ok_code.

thanks

venki