SYNCH message type use?

[Former Member]

Hi All,

I configured the ALE settings to send material from client 250 to 214 on the same ECC system. i configured all the steps correctly. But the scenario wouldnt work until I added a SYNCH message type in the partner profile of the 214 client. But i have done scenarios in which the config worked even without the synch interface. Why does this happen? What is the purpose of this SYNCH interface?

[Former Member]

Hi,

Inorder to provide successful distribution of a model to the concerned systems, SYNCH Message type has to be maintained. If this message type is not maintained the distribution is not successful and the system throws a error "RFC destination for synchronous communication, Partner Profile XXXXXX, SYNCH doesnot exist".

To overcome this you would be asked to Generate Outbound partner profile for message type SYNCH.

~Krithika

[GauthamV]

Hi,

you dont need to add SYNCH explicitly ,once you genarate the partner profiles

and distribute your view in BD64 it will automatically get reflected in WE20.

[Former Member]

thanks