Community
Application Development and Automation Discussions
Join the discussions or start your own on all things application development, including tools and APIs, programming models, and keeping your skills sharp.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
Read only

status LIS9 does not exist for interface mp000200

GirieshM
Active Contributor

‎2011 Mar 16 5:17 AM

0 Likes
409

Hi,

I am facing issue but not in IT0001, it is in IT0002.

It shows the error message that "status LIS9 does not exist for interface mp000200".

When i googled i found that TC 1 should not be used for delimit action.

I had did the same error and now i changed the TC.

Is it the only problem for showing that error message???

currently I am using COP for delimiting.

Kindly advice.

Hi,

I am facing issue but not in IT0001, it is in IT0002.

It shows the error message that "status LIS9 does not exist for interface mp000200".

When i googled i found that TC 1 should not be used for delimit action.

I had did the same error and now i changed the TC.

Is it the only problem for showing that error message???

currently I am using COP for delimiting.

Kindly advice.

Reply
1 REPLY 1
Read only

Former Member

‎2011 Mar 16 6:37 AM

0 Likes
371

Hi

Yes the reason for the error is TC 1. But you should not be changing the TC for any standard infotypes, as there is lot of things which are controlled in other programs based on the TC.

Regards

Ranganath