Split container

[Former Member]

hy all, i'm facing an issue with splitting my container.

I need to split my container in 2 columns. the right column should have only one row, but the second column must have 2 rows.

i started with a docking container dock at top, but when i split the left container in 2 rows, the second rows goes under the left coloumn. How to avoid that?

Is it the right choice to use the docking container?

Thanx in advance.

[Former Member]

hy all, i'm facing an issue with splitting my container.

I need to split my container in 2 columns. the right column should have only one row, but the second column must have 2 rows.

i started with a docking container dock at top, but when i split the left container in 2 rows, the second rows goes under the left coloumn. How to avoid that?

Is it the right choice to use the docking container?

Thanx in advance.

[Clemenss]

Hi EBONGUE ANDRE,

if you want to split a container, then you should create a splitter container of type CL_GUI_SPLITTER_CONTAINER or CL_GUI_EASY_SPLITTER_CONTAINER. First create a splitter with 2 columns, split vertical. Then create a second splitter in one column, split horizontal.

Everything may be placed in a docking container. This is quite easy because you will not need any control area in a screen (dynpro) because the docking container will dock to any screen, also selection screen.

You must make sure that container creation happens at PBO.

Regards,

Clemens

[Former Member]

solve it. thanx.