Smartform Continuous DotMatrix Printing, 2nd Page Moved Up

[suwandi_cahyadi]

Hi all,

I've developed a smartform to be printed using an Epson dotmatrix printer. The paper is a continuous paper. The print result is perfect for the 1st page, but when it continue to the second page, the layout is moved up a little bit (an inch or so).

I used DINA4 page format in the smartform and I found out that the actual paper size is slightly larger than DINA4.

If I change the page size in the smartform to match the actual paper size, will it solve the problem? Should there be other configuration needs to be checked/done?

Thank you.

[suwandi_cahyadi]

Hi all,

I've developed a smartform to be printed using an Epson dotmatrix printer. The paper is a continuous paper. The print result is perfect for the 1st page, but when it continue to the second page, the layout is moved up a little bit (an inch or so).

I used DINA4 page format in the smartform and I found out that the actual paper size is slightly larger than DINA4.

If I change the page size in the smartform to match the actual paper size, will it solve the problem? Should there be other configuration needs to be checked/done?

Thank you.

[pavanm592]

Hi Suwandi Cahyadi,

Check your output device in SPAD enter your device type>click on display >go to > device type>Formats>Double click on DINA4 and

In there you can find End of page format double click on it and enter /n in 2 lines

after saving this check your print again .We have done similarly for the same issue in TVS printer .

Hope this will solve your requirement .

regards,

Pavan