select statement with package size

[Former Member]

Hi,

is there any way where i can loop the package size within select statement, say for ex.

select * from tstc into table itab package size 1000.

write : sy-dbcnt.

loop into ipackage

do processing

endloop.

endselect.

the output will be 1000 2000 3000 .... 10000

here can i loop the above data in chunk of 1000 till the last record of table i.e. output first 1000 records than next 1000 and so on...

& this i want to complete in single select statement.please let me

is this possible on the ECC 6.0 system.

Thanks,

John.

[Former Member]

Hi John dias ,

I dont think this can be done in one hit. We too tried for this earlier but we have written logic for this. Please let me know if U can find solution for this.

[Former Member]

hi

good

i dont think there is any process which ll allow you to loop tha package size within the select satement.

thanks

mrutyun^

[Clemenss]

Hi John,

maybe i haven't got the question right. I tried this:

FORM package .
  DATA:
    lt_but000                               TYPE TABLE OF but000.
  FIELD-SYMBOLS:
    <but000>                                TYPE but000.
  SELECT
    partner bu_sort1
    INTO CORRESPONDING FIELDS OF TABLE lt_but000
    PACKAGE SIZE 100
    FROM but000.
    WRITE: / sy-dbcnt.
* some processing - i  this case it does not make too much sense
    LOOP AT lt_but000 ASSIGNING <but000>.
*      AT FIRST.
*        WRITE: /.
*      ENDAT.
*      WRITE: <but000>-bu_sort1(1).
    ENDLOOP.
  ENDSELECT.
ENDFORM.                    " package

and it works very well. I commented out the processing in the LOOP to get the output

100

200

...

1.400

1.441

in development system. Don't mind about me using field-symbol. It is the same as INTO clause but faster. In the loop you can do what you want to do with the data.

Regards,

Clemens

[Former Member]

we cannot loop through the package size since it is not an variable