Select Options Error

[Former Member]

Hi,

I have one requirement with select options.

I am trying to read the select option values in one Subroutine, but it is giving error

" No structure found with S_KUNNR and no value LOW'.

code is like this.

*********************************

selection-screen S_KUNNR FOR VBPA-KUNNR.

INCLUDE FORM.

PERFORM SUB_DISPLAY.

"

"

"

FORM SUB_DISPLAY.

KUNNRLOW = S_KUNNR-LOW.

KUNNRHIGH = S_KUNNR-HIGH.

ENDFORM.

i am not getting data from S_KUNNR-LOW TO KUNNRLOW.

Please answer asap..

Thanks in Advance.

Kumar A.

[Former Member]

Hi anil,

I'm convinced you already found the solution. Everybody will be delighted if you mark this question as solved and let people know the solution.

Regards,

Clemens

[Clemenss]

Hi anil,

if you have a requirement with select-options then you should use select-options.

selection-screen S_KUNNR FOR VBPA-KUNNR

does not look like syntactically correct.

select-options S_KUNNR FOR VBPA-KUNNR.

is better.

And you must make sure that somethng has been entered.

FORM SUB_DISPLAY.
read table S_KUNNR[] index 1.
check sy-subrc = 0-
KUNNRLOW = S_KUNNR-LOW.
KUNNRHIGH = S_KUNNR-HIGH.

Regards,

Clemens

[Former Member]

Hi,

It should be SELECT-OPTIONS and not selection screen.

Sri

[Former Member]

Hi,

First of all as mentioned in the earlier replies, it should select-options, not selection-screen.

As far as reading data is concerned, the event where you are trying to read data is important.

If you are trying to retrieve value in the event "AT SELECTION-SCREEN", definitely you will get the value.

If you are trying in the events such as "ON VALUE-REQUEST", you have to use DYNPREAD to retrieve data from the selection screen fields, otherwise the values will be initial.

Regards,

Hema

[Former Member]

Hi Anil,

Check the below code.

data v_num(3) type n.

select-options: s_num for v_num.

if s_num-low is initial and

s_num-high is initial.

s_num-low = 1.

s_num-high = 5.

elseif s_num-high is initial.

s_num-high = s_num-low.

elseif s_num-low is initial.

s_num-low = s_num-high.

endif.

while s_num-low le s_num-high.

perform my_num using s_num-low.

s_num-low = s_num-low + 1.

endwhile.

form my_num using p_num.

write:/ p_num.

endform.

Message was edited by:

Velangini Showry Maria Kumar Bandanadham

[kanthimathikris]

It should be,

data : v_kunnr type VBPA-KUNNR.

select-options S_KUNNR FOR v_kunnr .

[Clemenss]

Hi anil,

I'm convinced you already found the solution. Everybody will be delighted if you mark this question as solved and let people know the solution.

Regards,

Clemens