se30

[Former Member]

hi,

1) may i know why the time taken so much different from 1 run to another? if little change is reasonable but now its very large gap.

i check the database table fetching, sometimes very low sometimes very high. i try to optimise it by not using sql too much but the result in se30 really not stable.

i really do not know if my changes ok or not?

2) another question is, in se30, when click analyse button, there is a bar chart for abap and database and r/3 sysyem. why sometimes green and sometimes read?

what does it mean?

thanks

[Former Member]

hi,

1) may i know why the time taken so much different from 1 run to another? if little change is reasonable but now its very large gap.

i check the database table fetching, sometimes very low sometimes very high. i try to optimise it by not using sql too much but the result in se30 really not stable.

i really do not know if my changes ok or not?

2) another question is, in se30, when click analyse button, there is a bar chart for abap and database and r/3 sysyem. why sometimes green and sometimes read?

what does it mean?

thanks

[Former Member]

Hi Eliana,

check below SAP help, you may find the information

http://help.sap.com/saphelp_nw2004s/helpdata/en/c6/617cafe68c11d2b2ab080009b43351/frameset.htm

Regards,

Atish

[Former Member]

HI Eliana,

I ll try to help u.

1) Do you have to consider the first time when you use the SE30. Because in the second time the buffer its being charged. So, make a logoff after the test in SE30 and try again.

2)

Green - good performance

red - bad performance ( give more attention to these cases )

Juliano Diniz