SCI AUTOMATION

[Former Member]

I am getting error 'there is no inspection' while executing fm 'SCI_GET_INSPECTION_PLAIN_LIST'

to get result as plain list directly.

[Former Member]

hi,

Run FM in debugging mode and set break point at statement and then F8 which will stop the cursor at the place where error message has been raised then you analyse the cause of the error.

you can set break point by following below path.

breakpoints->breakpoint at->breakpoint at statement->type 'message' under ABAP Cmnds column.

Thanks.

[RobertVit]

Please be more specific and check community rules

[NTeunckens]

Please go through basic Debugging and see why this Message is Raised when executing the Function Module ...

I believe the Message is "SCI 050" and it is probably raised on one of the very first Steps withing the Logic of the FM ...

[cdprasanna]

hi,

Run FM in debugging mode and set break point at statement and then F8 which will stop the cursor at the place where error message has been raised then you analyse the cause of the error.

you can set break point by following below path.

breakpoints->breakpoint at->breakpoint at statement->type 'message' under ABAP Cmnds column.

Thanks.