Community
Application Development and Automation Discussions
Join the discussions or start your own on all things application development, including tools and APIs, programming models, and keeping your skills sharp.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
Read only

Report: Get USER-Comand from subscreen?

Go to solution
Former Member

‎2015 Dec 18 9:51 AM

0 Likes
758

Hi all,

I wrote a report:

SELECTION-SCREEN BEGIN OF SCREEN 100 AS SUBSCREEN.
PARAMETERS: p1 TYPE c LENGTH 10,
            p2 TYPE c LENGTH 10,
            p3 TYPE c LENGTH 10.
SELECTION-SCREEN END OF SCREEN 100.

SELECTION-SCREEN BEGIN OF SCREEN 200 AS SUBSCREEN.
PARAMETERS: q1 TYPE c LENGTH 10,
            q2 TYPE c LENGTH 10,
            q3 TYPE c LENGTH 10.
SELECTION-SCREEN END OF SCREEN 200.

SELECTION-SCREEN: BEGIN OF TABBED BLOCK mytab FOR 10 LINES,
                  TAB (20) button1 USER-COMMAND push1
                                   DEFAULT SCREEN 100,
                  TAB (20) button2 USER-COMMAND push2
                                   DEFAULT SCREEN 200,
                  END OF BLOCK mytab.

INITIALIZATION.
  button1 = 'Selection Screen 1'.
  button2 = 'Selection Screen 2'.

When the user now start the ABAP, ow do I know, wich subscreen is active (Wich user command was fired)?

Thanks

Regards

Mario

1 ACCEPTED SOLUTION
Read only

Go to solution
apratsch
Explorer

‎2015 Dec 21 11:57 PM

0 Likes
718

Hi Mario,

you need to use event AT SELECTION-SCREEN. There you can get the user command from field SY-UCOMM after one of the tabs was clicked.


Best regards,

Andreas

Hi all,

I wrote a report:

SELECTION-SCREEN BEGIN OF SCREEN 100 AS SUBSCREEN.
PARAMETERS: p1 TYPE c LENGTH 10,
            p2 TYPE c LENGTH 10,
            p3 TYPE c LENGTH 10.
SELECTION-SCREEN END OF SCREEN 100.

SELECTION-SCREEN BEGIN OF SCREEN 200 AS SUBSCREEN.
PARAMETERS: q1 TYPE c LENGTH 10,
            q2 TYPE c LENGTH 10,
            q3 TYPE c LENGTH 10.
SELECTION-SCREEN END OF SCREEN 200.

SELECTION-SCREEN: BEGIN OF TABBED BLOCK mytab FOR 10 LINES,
                  TAB (20) button1 USER-COMMAND push1
                                   DEFAULT SCREEN 100,
                  TAB (20) button2 USER-COMMAND push2
                                   DEFAULT SCREEN 200,
                  END OF BLOCK mytab.

INITIALIZATION.
  button1 = 'Selection Screen 1'.
  button2 = 'Selection Screen 2'.

When the user now start the ABAP, ow do I know, wich subscreen is active (Wich user command was fired)?

Thanks

Regards

Mario

Reply
2 REPLIES 2
Read only

Go to solution
apratsch
Explorer

‎2015 Dec 21 11:57 PM

0 Likes
719

Hi Mario,

you need to use event AT SELECTION-SCREEN. There you can get the user command from field SY-UCOMM after one of the tabs was clicked.


Best regards,

Andreas

Read only

Go to solution
Former Member
In response to apratsch

‎2015 Dec 22 6:51 AM

0 Likes
718

Hi Andreas,

danke!

Regards

Mario