Remote enable module - exceptions issue

[Former Member]

Hello all,

I have a function module.

I choosed to make it RFC : Remote enable module.

Then I got the message During RFC/update, no exception classes can be used, when I try to check it.

So I commented all parts regarding exceptions, deleted the Exceptions part .

And I still receive the same message

I don't know what else to do... Does anybody has an advice ?

Thank you !!!

[Former Member]

Hi Ariana,

Try not to use exceptions in an RFC, collect all the error in a return table rather than giving an exceptions.

If possible try to show the code which you have written.

Regards,

Prashant

[SuhaSaha]

Hello Ariana,

Can you share your code with us ?

BR,

Suhas

[Former Member]

Did you remove the exceptions from the FM interface?

Rob

[Former Member]

Hi Ariana,

Try not to use exceptions in an RFC, collect all the error in a return table rather than giving an exceptions.

If possible try to show the code which you have written.

Regards,

Prashant

[Sm1tje]

Ariana,

on the exception tab of your RFC, you must have marked the checkbox 'Exceptn Classes' (checkbox just above your first exception). Uncheck this and you'll be fine.

[uwe_schieferstein]

Hello Ariana

Most likely there is an exception class defined in the signature of your function module.

Remove the exception class and replace it with a standard exception and then the compilation error should disappear.

However, RFC-enabled fm's should not raise any exception because otherwise the RFC connection will dump. Instead, return the errors as messages in a RETURN parameter (of table type BAPIRETTAB) like it is done in BAPIs.

Regards

Uwe