Reg:Report Painter in CO module

[p291102]

Dear all,

This is one of Std program - GP5DCDGCG2TA0184K1FSBBOHX4P. This program is belongs to KE80 STD SAP TC(tcode). When i am assigning this standard program to my Ztcode i am getting the different input selection screen which is i am getting when i am executing the standard transaction code . What would be the problem that i don't know?

Thanks,

Sankar M

[p291102]

Dear all,

This is one of Std program - GP5DCDGCG2TA0184K1FSBBOHX4P. This program is belongs to KE80 STD SAP TC(tcode). When i am assigning this standard program to my Ztcode i am getting the different input selection screen which is i am getting when i am executing the standard transaction code . What would be the problem that i don't know?

Thanks,

Sankar M

[Former Member]

Hi Sankar,

For tcode : KE80 the standard program is SAPMKCEE.

Check whether GP5DCDGCG2TA0184K1FSBBOHX4P program exists?

Regards,

Sravanthi

[p291102]

NO .In that TC after going inside we can able to see lot of reports inbuilt in that TC. If we are choosing that different reports we can able to see this different G* programs. Please ensure that one also.