Structured Variables as Parameters.

[Former Member]

Hello Gurus,

How can we use structured variables as parameters. Here is the code that I am working on.

abap.

call method abc=>xyz

exporting 123 = 456

345 = 678

importing 012 = 345.

endabap.

log ( 345 ).

chetab ( ijk , ijk_1 ).

So when i run the script i notice that log ( 345 ) gives me:-

log 345 = XML-DATA-01

Parameter

1

a

b

c

2

a

b

c

Now 345 is a table with diff fields (a, b, c) and multiple records (1, 2,..). In chetab command interface I have to give b and c field values to compare and is it also possible to repeat the check for diff records. Please help me with this.

Thanks,

GS.

[Former Member]

Hello Gurus,

How can we use structured variables as parameters. Here is the code that I am working on.

abap.

call method abc=>xyz

exporting 123 = 456

345 = 678

importing 012 = 345.

endabap.

log ( 345 ).

chetab ( ijk , ijk_1 ).

So when i run the script i notice that log ( 345 ) gives me:-

log 345 = XML-DATA-01

Parameter

1

a

b

c

2

a

b

c

Now 345 is a table with diff fields (a, b, c) and multiple records (1, 2,..). In chetab command interface I have to give b and c field values to compare and is it also possible to repeat the check for diff records. Please help me with this.

Thanks,

GS.

[Former Member]

Hello Gurus,

My question now is half answered. I am able to pass a, b values in CHETAB command. All I had to do was in CHETAB command interface for element a, b i entered the value as X[1]-a and X[1]-b.

However as mentioned earlier X[] has multiple records say 5. So i have to check table entries for 5 records. I have writted my CHETAB command in DO loop. However everytime it takes X[1]-a and X[1]-b.

So, all I need now is, can it take X[2]-a and X[2]-b, X[3]-a and X[3]-b, ... for each iteration in the DO loop. I dont know whether its possible. But if it is then please can anybody help me on this.

Thanks,

GS

Note: Sorry Gurus, please replace X with 345 in this message.

Edited by: Get Started on Apr 4, 2009 12:41 AM

[Vny12]

Hi,

use the code below.

Do 5 .

variable abc = x[&lpc]-a.

variable qwe = x[&lpc]-b.

CHETAB ---> pass abc and qwe or x[&lpc]-a and x[&lpc]-b.

in the interface,

clear chetab_1.

end loop

since chetab is in loop.

refresh the chetab interface so that every time in loop new data gets inn.

regards

vinay

[Former Member]

Hello Vinay,

I have done the same thing and was able to use the structured variables as parameters. Thank you so much for reply. Now that you have taken some time in writing a mail, I have awarded the points to you.

Thanks,

GS