problem with user-exit

[Former Member]

Hi everyone,

I was give to add a few lines of code to a user exits 'exit_saplbarm_001' and 'exit_saplbarm_002'.

I went to transaction se37 to change the function module exit_saplbarm_001.But it is not allowing me to change the code there.So i created a new project with z* in CMOD.after creating the project i went to the enhancement assignment and tried to enter the enhancement name 'saplbarm' but it says that enhancement doesn't exists.

How can i find the particular enhancement for the above exits?am i going in the right way?any suggestions please.

Thank you.

[Former Member]

you have to ignore this warning message...

if the system asks, if you want to create the include, say yes...

[JozsefSzikszai]

hi d p,

this information is in table MODSAP

Exit: EXIT_SAPLBARM_001

Enhacement: XMRM0001

same for the other

hope thishelps

ec

[Former Member]

Hi

Use the Enhancment

<b>XMRM0001</b>

which is related to your Exits

assign it in CMOD and write the code an use it

Regards

Anji

[Former Member]

Thanks Eric and Anji reddy.I will try with the enhancement u gave.

[gopi_narendra]

Hi

Goto CMOD tcode

give a Zname for the project , give a description

now Save and click on the enhancement assingments -- > give in the enhancement as XMRM0001 and press on the Components button.

which shows you the function moudles double clk on the fms and then double clk on the Z includes in the fm's to include your code

Regards

Gopi

[Former Member]

Hi

I got the exits with the enhancement XMRM0001.When i went into the exit and double clicked the include to add the code it is giving a warning message in the status bar saying " Program names ZX... are reserved for includes of exit function groups".

What should I do?

[JozsefSzikszai]

you have to ignore this warning message...

if the system asks, if you want to create the include, say yes...

[gopi_narendra]

Just press enter and go ahead in creating the includes

those are just warning messages

Regards

Gopi

[Former Member]

Hi all thanks for guiding that worked when i pressed enter.I able to change in the include.

one last thing i need to add a line of code in the function pool xmrm(zxmrmtop).I couldn't find this in the components.How can I change this?

[Former Member]

Hi Eric

Thanks for guiding that worked when i pressed enter.I able to change in the include.

one last thing i need to add a line of code in the function: pool xmrm(zxmrmtop).I couldn't find this in the components.How can I change this?

[JozsefSzikszai]

when you are in changing the function, menu: GOTo / Global data

that is the TOP include and you can change it there.

alternatively you can have a look at the Function Group in SE80, where you should see each single include, this one as well

[Former Member]

Hi Eric,

Thank you.ur suggestions solved my issue.

[JozsefSzikszai]

OK, than you can assign ten points for providing the solution...