Problem with configure Message Control

[Former Member]

Hello everyone,

Can you please help me with such issue. I want to configure through message control creation of Idoc through EDI. It means that after Creation or Changing PO (me21n, me22n) I suppose to get at output Idoc. I did configuration such as creating Partners Profiles, Ports RFC etc , for example as it showed in this topic

but still no matter do I save a new PO or change existing one I still have my messages in status yellow means message not processed.

Can you please kindly help me what is my mistake or what I do wrong .

[JL23]

What timing did you enter in the message condition?

4 = immediate processing when saving the PO.

otherwise you have to execute message processing in ME9F or with a background job.

[Former Member]

And with ME9F I don't see message output for me PO

[Former Member]

Yes, I entered 4 immediate processing

[JL23]

are you sure that the PO is not under a release strategy.

It is normal that a message is created, but it gets only process after the PO gets released.

It is not foreseen to output or send a message when the PO is not approved.

Please check in the PO header if you have a release tab and if the PO  has its final approval

[Former Member]

Yes you are correct in it! I'm not functional consultant so not even knew about me29n.

Thank you very much!!!!! After I released it Idoc was created!!