problem with BAPI_MATERIAL_SAVEDATA ...!

[Former Member]

Hi All,

I am using BAPI_MATERIAL_SAVEDATA to extend the materials from on plant to another plant. the program is working fine for first time when i am extending from source plant (ex. 1000) to destination plant (eg.2000) . but the problem is when i am extending from another plant like 3000 to 2000 , it is not trowing the error stating that it has been already extended instead of that it is allowing to extend which is not a right case.

Please suggest , any additional parameters i need to pass to restrict this one.

Regards,

Suresh 

[Former Member]

Good afternoon Suresh,

you have to confirm if the plant you are extending the material has the material. if it does not have the material , you should not have that error message. again hope while you were extending the material you did not change the name of the material

[Former Member]

Please reply.

[JL23]

Do you do any check in your program to see if the material already exists.

If not- do it

if yes, explain  how you react on this circumstance.

[former_member183529]

Good afternoon Suresh,

you have to confirm if the plant you are extending the material has the material. if it does not have the material , you should not have that error message. again hope while you were extending the material you did not change the name of the material