Community
Application Development and Automation Discussions
Join the discussions or start your own on all things application development, including tools and APIs, programming models, and keeping your skills sharp.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
Read only

Printing issue in Smartforms

Former Member

‎2013 May 31 1:42 PM

0 Likes
761

Dear Experts,

I have a issue in smartform printing.

Whenever I take a printout from Laser Printer the font of the printout appears to be perfectly fine but whenever I take a printout from Dot Matrix Printer then the font appears to be smokey as if the print is in 3D format.

Secondly, I am printing a GR form through Dot Matrix Printer and the page format in the smartform is of

25 CM width &

15 CM Height..

i.e. on A4 size of paper 2 GR's forms will get printed and it gets printed on Pre-printed paper..

But the issue is whenever 2 GR's are printed, first GR gets printed on the 1st pre-printed form and the second GR gets printed on the 3rd Pre-Printed form.

second forms is left blank while printing the  2 GR's..

Regards,

Mahesh

Dear Experts,

I have a issue in smartform printing.

Whenever I take a printout from Laser Printer the font of the printout appears to be perfectly fine but whenever I take a printout from Dot Matrix Printer then the font appears to be smokey as if the print is in 3D format.

Secondly, I am printing a GR form through Dot Matrix Printer and the page format in the smartform is of

25 CM width &

15 CM Height..

i.e. on A4 size of paper 2 GR's forms will get printed and it gets printed on Pre-printed paper..

But the issue is whenever 2 GR's are printed, first GR gets printed on the 1st pre-printed form and the second GR gets printed on the 3rd Pre-Printed form.

second forms is left blank while printing the  2 GR's..

Regards,

Mahesh

Reply
4 REPLIES 4
Read only

Former Member

‎2013 May 31 3:05 PM

0 Likes
690

HI its dependent on printer.

Configure your default printer as dot-matrix using Transaction SPAD.

And arrange font as par dot matrix .

Read only

Former Member

‎2013 May 31 5:24 PM

0 Likes
690

This message was moderated.

Read only

venkateswaran_k
Active Contributor

‎2013 May 31 10:29 PM

0 Likes
690

Hi

You need to confirm the Page Size specified in the smartform is matches with the Printer configuration using SPAD.

Regards,

Venkat

Read only

TSG
Participant

‎2013 Jun 01 1:15 PM

0 Likes
690

Hi,

please try to used standard printer device type instead of configure new device type

SPAD.

Ex: your printer is Epson then used Epson_x device type and page format compatible for that printer.