Partner profile Config

[Former Member]

Hi ,

I have configured in outbound and inbound parameters for my IDOC-DELVRY05.

I have even maintained the distribution model in bd64 for my custom message type.

I have linked my custom message type to the IDOC type and its extension ZDELVRY05.

But still when I am trying to generate IDOC using program RSNAS00, I am getting error message as "Partner profile not found".

Please advice what should I do.

[Former Member]

Hi ,

I have configured in outbound and inbound parameters for my IDOC-DELVRY05.

I have even maintained the distribution model in bd64 for my custom message type.

I have linked my custom message type to the IDOC type and its extension ZDELVRY05.

But still when I am trying to generate IDOC using program RSNAS00, I am getting error message as "Partner profile not found".

Please advice what should I do.

[Former Member]

Have defined message control in partner profile ? if not please config.

Here you have to supply Application,output type and Process code.

Thanks

Seshu

[Former Member]

Hi,

Run TCODE - WE20. Partner type LS you can see your Source System "partner profile". check the existence of your flat file soursystem - "partner profile".

if it isn't existed you have to create one.

[Former Member]

Hi Abhishek,

- Goto WE20 and select the partner type from Partner type LS.

- Select your message type form Outbound parameters (If Outbound) or Inbound parameters(If inbound) and D-click.

- Check the receiver port exists and you mentioned Basic Idoc type and Extension type in the Idoc type Tab.

I hope it will solve your problem.

Regards,

Ranjith.