module at-exit command

[Former Member]

Hi,

Inside this module I have logic for ok_code

WHEN 'EXIT'.

perform pop_up.

form pop_up.

function module: do you want to save the changes?

if yes.

" perform save_changes.

" leave program

for msave_changes.

perform incompletion_logic.

" save changes

endform.

when iam doing this I have error messages for incompletion inside the incompletion_logic routine.

and when i issue an error message

iam getting short dump saying 'error message inside module atexit command' invalid dynpro state'.

what is the correct process to do this.

Thanks

[Former Member]

Hi,

Inside this module I have logic for ok_code

WHEN 'EXIT'.

perform pop_up.

form pop_up.

function module: do you want to save the changes?

if yes.

" perform save_changes.

" leave program

for msave_changes.

perform incompletion_logic.

" save changes

endform.

when iam doing this I have error messages for incompletion inside the incompletion_logic routine.

and when i issue an error message

iam getting short dump saying 'error message inside module atexit command' invalid dynpro state'.

what is the correct process to do this.

Thanks

[Former Member]

Like the system message, you cannot throw a error message inside the AT_EXIT module.

You can call that module, in the PAI (Not at AT-EXIT command) and call the popup and do the required validations.

Regards,

Ravi

Note :Please mark the helpful answers

[Former Member]

Hi KP,

Remove the Functional type for your "exit and cancel buttons" as 'E'. and then write your code in a module without at exit command.

Regards,

Ravi