Material_Master_User_Exit

[Former Member]

Hi..

I want to know the user exit in material master where if anyone has changed the material then I should capture that change and if the material belongs to our plant then I want to update a customised table.

What is the user-exit in which I can perform the above operations?

Thanks

[Former Member]

Hi Subhash,

Try Enhancement MGA00001 in SMOD and see if it helps. This gets triggerd on SAVE from MM01 and MM02.

Check this Enhancement MGA00002 and also Check these BADI's

BADI_MATERIAL_CHECK

BADI_MATERIAL_OD

BADI_MATERIAL_REF

Cheers

VJ

Message was edited by: Vijayendra Rao

[Former Member]

I'm not sure if there is a user-exit where you can do this. If you can't find one, you could create a custom message type and active change pointer processing for that message type. You can then define a custom program to process change pointers for that message type adding whatever processing logic you need.

Look at function MASTERIDOC_CREATE_SMD_MATMAS.

[Former Member]

Hi Subhash,

Try Enhancement MGA00001 in SMOD and see if it helps. This gets triggerd on SAVE from MM01 and MM02.

Check this Enhancement MGA00002 and also Check these BADI's

BADI_MATERIAL_CHECK

BADI_MATERIAL_OD

BADI_MATERIAL_REF

Cheers

VJ

Message was edited by: Vijayendra Rao

[Former Member]

You can try with enhancements

MGA00001

MGA00002

MGA00003

regards

[Former Member]

hi

good

check with these user exits

for mm01->

MGA00001 Material Master (Industry): Checks and Enhancements

MGA00002 Material Master (Industry): Number Assignment

MGA00003 Material Master (Industry and Retail): Number Display

for mm02->

MGA00001 Material Master (Industry): Checks and Enhancements

MGA00002 Material Master (Industry): Number Assignment

MGA00003 Material Master (Industry and Retail): Number Display

thanks

mrutyun

Message was edited by: Mrutyunjaya Tripathy

[Former Member]

Hi

Thank you all for your answers.

But Mrutyunjaya, how were you able to locate the enhancements MGA00001 etc because when I pressed F4 and then F6 in the transaction CMOD, (which is a general procedure to find a User-Exit), I couldn't find any.

So please tell me how were you able to trace out those enhancements?

Thank you

[alison_lloyd]

in smod not cmod, f4 and enter description e.g. aterialaster*