Community
Application Development and Automation Discussions
Join the discussions or start your own on all things application development, including tools and APIs, programming models, and keeping your skills sharp.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
Read only

IW32, OID1, smartform and driver program configuration.

maksingh8
Explorer

‎2016 Jan 10 7:19 AM

0 Likes
1,897

Hello Everyone,

I got a requirement to replace the SAP script PM_COMMON with a 'Z' smartform in IW32.

As per consultant instruction I copied the standard program RIPRCT00 to a 'Z' program say 'ZRIPRCT00'. And modified it to call my smartform from here.I requested consultant to configure the smartform and driver program for the transaction IW32, and he confirmed he did it.

Now the problem is even after configuration system is still calling the standard program RIPRCT00 not my 'Z' program 'ZRIPRCT00'.

In transaction; OID1 and application area 'O' it shows two relevant records now.

First record, which is standard and last which is created by consultant. (Refer attachment)

Can you please tell me how can I call my 'Z' program here instead of standard program ?

I cant take help of consultant as he is not available for some days and there is no replacement.

Thanks & Regards,
Mayank

Preview file
68 KB

Hello Everyone,

I got a requirement to replace the SAP script PM_COMMON with a 'Z' smartform in IW32.

As per consultant instruction I copied the standard program RIPRCT00 to a 'Z' program say 'ZRIPRCT00'. And modified it to call my smartform from here.I requested consultant to configure the smartform and driver program for the transaction IW32, and he confirmed he did it.

Now the problem is even after configuration system is still calling the standard program RIPRCT00 not my 'Z' program 'ZRIPRCT00'.

In transaction; OID1 and application area 'O' it shows two relevant records now.

First record, which is standard and last which is created by consultant. (Refer attachment)

Can you please tell me how can I call my 'Z' program here instead of standard program ?

I cant take help of consultant as he is not available for some days and there is no replacement.

Thanks & Regards,
Mayank

Reply
1 REPLY 1
Read only

jogeswararao_kavala
Active Contributor

‎2016 Jan 10 8:52 AM

0 Likes
1,279

Hello Mayank,

The solution could lie in tcode OID2, where the Selection check-box needs to be ticked for Z shop paper and un-ticked for Standard shop paper. The pictures below explain the same.

Good luck

KJogeswaraRao

Preview file
50 KB
Preview file
40 KB