IDOCS

[Former Member]

Hi Gurus,

This is a question related to IDOCS.Please give me your valuable suggestions.

I have to send data from single source system to multiple target systems,so i do i establish the link between the source and target systems.Either in BD64 or at some other place.

Also the data to be sent to these target systems is same.but If i find different segments in these target system, how to rectify this.

If the question is not clearly explained,please ask for the same.

Thanks in advance.

[Former Member]

Hi Gurus,

This is a question related to IDOCS.Please give me your valuable suggestions.

I have to send data from single source system to multiple target systems,so i do i establish the link between the source and target systems.Either in BD64 or at some other place.

Also the data to be sent to these target systems is same.but If i find different segments in these target system, how to rectify this.

If the question is not clearly explained,please ask for the same.

Thanks in advance.

[Former Member]

Hello,

In the Transaction BD64, when you set up the Distribution Model, what you can do is you can set up Filters & Conversions on the Segments / Fields that you want to send to different people based on your requirement.For this, you need to go to the Transaction BD56 and set up Segment Filters for different Receipients. In this way, you can restrict some of the segments not being sent to some of the Receipients.

Hope it was clear.

Thanks and Regards,

Venkat Phani Prasad Konduri

[Former Member]

Thanks a lot venkat.

I have awarded the forum points.

I have three systems in which the segments are filtered,but i find only one system in the list. can you please tell me why is it so.

Thank you.

[Former Member]

hi

Segment filters are set to filter out the data sent to external system, if you want to send same data to three systems and it is transactionl data simply maintian partner profiles and it depends what is your trigger point, how you are creating idocs using message control or bespoke program or change pointers

cheers

[shivhare]

Hi,

i think you have already define logical system(Receiver) then create distribution module where you give sender system and receiver system and message type then go BD52. And i think now you can see your receiver system system

Thanks