IDoc Status

[Former Member]

Hello All,

I am trying to post some IDocs manually and when I do that I get the IDocs set to status 51, displays an error saying "Negative values not allowed" for some,.

Few other IDocs gives an error display "Error occured from Conversion of Unit from CON to PCK".

I would appreciate your input on this.

Thank you,

Rajesh.

[Former Member]

Hello All,

I am trying to post some IDocs manually and when I do that I get the IDocs set to status 51, displays an error saying "Negative values not allowed" for some,.

Few other IDocs gives an error display "Error occured from Conversion of Unit from CON to PCK".

I would appreciate your input on this.

Thank you,

Rajesh.

[Former Member]

Hi,

These are functional errors, show these to your functional consultant.

1. You are trying to pass a -ve value to a field, which is not accepting the same.

2. There are two different UoM being used and the system is unable to convert them as probably the conversion factor is not maintained.

Regards,

Ravi

Note - Please mark all the helpful answers

[Former Member]

Thanks Ravi, that was helpful to a certain extent.

Thank you,

Rajeshwar.

[Former Member]

Hi,

<b>Error occured from Conversion of Unit from CON to PCK</b>

Check in the material master if there is conversion available from CON to PCK..

Please close the duplicate thread..

Thanks,

Naren

[Former Member]

Thanks Naren for your inputs.

Thank you,

Rajesh.