IDOC in Test Mode

[Former Member]

Hi,

I am using CREMAS

I am submiting program rbdapp01 to post the IDCOS

Now I want to run in TEST MODE (simulation run) , not to create any vendors , but it should give success and error messages as usual

I had found one TEST Flag on selection screen of rbdapp01 , i tried using that but it is giving message "No Data Selected"

Any inputs on this

thanks

chandra

Edited by: Chandrasekhar Jagarlamudi on May 3, 2008 12:44 AM

[Former Member]

Hi,

I am using CREMAS

I am submiting program rbdapp01 to post the IDCOS

Now I want to run in TEST MODE (simulation run) , not to create any vendors , but it should give success and error messages as usual

I had found one TEST Flag on selection screen of rbdapp01 , i tried using that but it is giving message "No Data Selected"

Any inputs on this

thanks

chandra

Edited by: Chandrasekhar Jagarlamudi on May 3, 2008 12:44 AM

[Former Member]

Hello Chandrasekhar, While I have not worked on this specifically here is what I think.

The test flag indicator is not what you think. You cannot take just any IDOC and set the test indicator on RBDAPP01 and "simulate" it.

in WE20 check the entry for any partner having CREMAS in the inbound profile. There you will find a field "Test flag". If that is checked for a particular partner that means any thing from that is in test mode and IDOCs from that Partner will be in TEST mode.

So RBDAPP01 will pick IDOC in status "64" and if you have idocs from this partner and test flag field set , only then they will be posted as TEST and not commited.

I hope you got my point. if in WE20 the TEST flag is not set then no matter what the rbdapp01 test flag does not do anything.

AGAIN i have not used this , but this is my best guess, as no one had replied , I posted this.

Regards

[Former Member]

Thanks Sandeep for the Reply,

But can we control the TEST flag in the partner Profile in our program

The Flag should be changed to X or space depending on the Test Run Checkbox checked on the selection screen of my program

thanks

chandra

[Former Member]

Sorry could not get back earlier.

I think you want to simulate a test, but it would be not such a good idea to include this flag in a program, I have never tried but this is for change through WE20 only , by the EDI group.

Try some other way to simulate.

Easy example is to include the words TEST in some field which is easily visible so users know its a test and would delete it later.

Example while testing PO's we used to prefix the PO number with TEST so there is no confusion.

Hope this helps.

Regards

Edited by: Sandeep Bhavsar on May 7, 2008 1:30 PM

[Former Member]

Hi,

Here you have to set the flag TEST in the partner profile.Then it will fulfil your requirements.

Thanks and regards,

shyla