How to Roll Back Table Conversion

[former_member597931]

I have created the structure and I have Appended to VBAP table. In Appended structure there is one zfield. I need to change in data element of the same field. There are some decimal no. changes. Earlier it was 3.1 and I must change it to 3.2. When I am trying to activate the Append Structure, since then VBAP table is Partially Activated State. So, here I did SE14 Adjust and Activate table, but it is showing short dump. Step 5 Error occur while adjusting. Even I tried reverting the changes and try to make it was at initial stage, but it doesn’t serve the solution. Even if I check the Error in in SE11, it is showing “Table is not existing in the Data base”, but I activate table again it going to dump.

My requirement is to bring back the VBAP table into its original state.

[former_member597931]

I have created the structure and I have Appended to VBAP table. In Appended structure there is one zfield. I need to change in data element of the same field. There are some decimal no. changes. Earlier it was 3.1 and I must change it to 3.2. When I am trying to activate the Append Structure, since then VBAP table is Partially Activated State. So, here I did SE14 Adjust and Activate table, but it is showing short dump. Step 5 Error occur while adjusting. Even I tried reverting the changes and try to make it was at initial stage, but it doesn’t serve the solution. Even if I check the Error in in SE11, it is showing “Table is not existing in the Data base”, but I activate table again it going to dump.

My requirement is to bring back the VBAP table into its original state.

[ruben_rollano]

Hello Ashwini,

It is not possible to Roll Back. You have to get the intermediate table generated and recover it.

Here you have an example of the conversion process:

https://help.sap.com/doc/saphelp_nwpi71/7.1/en-US/cf/21f1b8446011d189700000e8322d00/content.htm?no_c...

Here a note with the needed know how:

https://apps.support.sap.com/sap/support/knowledge/preview/en/1925322

And finally the FAQ: Table Conversion - Frequently Asked Questions

https://wiki.scn.sap.com/wiki/display/TechTSG/Table+Conversion+-+Frequently+Asked+Questions

Best regards.

[former_member597931]

Thanks, it is helpful.