Graphical Screenpainter doesn't support Unicode c

[Former Member]

Hi everyone, I installed the miniSAP NetWever 7.01, but I can not use screen painter tool because when I press Layout button, the message occur: "EU_SCRP_WN32: Graphical ScreenPainter does not support Unicode c". Could you help me ?

[Former Member]

Hi everyone, I installed the miniSAP NetWever 7.01, but I can not use screen painter tool because when I press Layout button, the message occur: "EU_SCRP_WN32: Graphical ScreenPainter does not support Unicode c". Could you help me ?

[former_member194416]

Hi,

Go sm59 tcode and find EU_SCRP_WN32 RFC destination. In RFC destination definition there are some options to make it work unicode or non-unicode change this option to non-unicode.

Also check your computer name and change it if it contains any non-ASCII characters or more than 14 characters (I recommend not to use something more than 10).

Regards

[Former Member]

I did as you say, but it still didn't work. When I pressed "connection test" button, that message occurred again.

[former_member194416]

Hi,

It worked in my case. If there is active firewall try to deactivate it and if it is still not working than check OSS Notes 204910, 101971, 885581.

Regards,

[Former Member]

Hi,

I already set non-unicode for EU_SCRP_WN32, and my computer name is only 6 characters. I turned off all firewalls, I reinstalled SAPGUI 7.2 also. BUT the error still occurred

How to check OSS Notes 204910, 101971, 885581?

PLEASE HELP ME GUYS!!!!

Thanks in advance!

[Former Member]

Hi all.

I have met the same error.

Have anyone find the solution for this.

Thanks in advance

----------------------------------------------------------

Update:

I have found the solution for this issue. In control panel, go Region and Language, choose tab Administrative and change the "Current language for non-Unicode programs" to English.

Hope it help.

Regards,

Teddy