flag

[Former Member]

why we use flag in if statement?

[Former Member]

hi,,

You can use flag for different purposes.Suppose we need to check any of the records being checked for a table you can use flag for that thing .If ther is any changes we can also use flag for that thing also.It depends on different situations.

regards,

veeresh

[Former Member]

Hi,

Not clear with your requirement...

not only flag...We can compare any variables / work areas / internal tables using IF statement..

Thanks,

Naren

[Former Member]

flag is used as a mediator,

In the below example records of itab are appended to itab1 except the first record on every change of MATNR , chk how the flag is used

loop at itab.

 at new matnr.
    v_flag = 'X'.
 endat.
 if v_flag eq 'X'.    
  clear flag.
 else.
   append itab to itab1.   
 endif.

endloop.

Message was edited by:

Chandrasekhar Jagarlamudi

Message was edited by:

Chandrasekhar Jagarlamudi

[former_member673464]

hi,,

You can use flag for different purposes.Suppose we need to check any of the records being checked for a table you can use flag for that thing .If ther is any changes we can also use flag for that thing also.It depends on different situations.

regards,

veeresh

[Former Member]

Hi Silla,

LOOP AT TAB.

IF TAB-FLAG IS INITIAL.

TAB-FLAG = 'X'.

ENDIF.

MODIFY TAB.

ENDLOOP.

TAB-FLAG = 'X'.

MODIFY TAB TRANSPORTING FLAG

WHERE FLAG IS INITIAL.

Rewords if it is helpful.

Rgds,

P.Nag