Extract ST22 Dump using ABAP Code into internal table for conversion to PDF

[Former Member]

Hello Everyone,

Is there any way to extract ST22 dump to internal table using our own ABAP program? I tried to imitate SAP coding but surely there must be an easy way to do it. I don't wish to go for BDC.

Here's where I have done, until now:

1. I looked into the program SAPMS380 and successfully extracted the SNAP Table entries by looking into EXTRACT_STRINGS_FROM_SNAP.

2. Subroutine PRODUCE_LIST does the final conversion of above data to meaningful Shortdump text in an internal table, but is there any other way to do this?

Finally, I have to convert the output internal  table to PDF which I can do.

Please help me out in this, or I will have to do this the long way. Your valuable suggestions are most welcome.

Best Regards,

Jagraj Singh

[Former Member]

Hello Everyone,

Is there any way to extract ST22 dump to internal table using our own ABAP program? I tried to imitate SAP coding but surely there must be an easy way to do it. I don't wish to go for BDC.

Here's where I have done, until now:

1. I looked into the program SAPMS380 and successfully extracted the SNAP Table entries by looking into EXTRACT_STRINGS_FROM_SNAP.

2. Subroutine PRODUCE_LIST does the final conversion of above data to meaningful Shortdump text in an internal table, but is there any other way to do this?

Finally, I have to convert the output internal  table to PDF which I can do.

Please help me out in this, or I will have to do this the long way. Your valuable suggestions are most welcome.

Best Regards,

Jagraj Singh

[Former Member]

You first need to convert your internal table data to OTF data using FM CONVERT_OTF, then convert OTF to PDF using FM CONVERT_OTF_TO_PDF....

[gregorygotera]

Hi

You can use the FM 'RS_ST22_GET_FT' for obtain all details about the dump

All parameters used for this FM, you can find these, inside the SNAP table.

Best regards

Gregory