Exit using Cancel button from form preview.

[Former Member]

Hi

I am looping into internal table and printing a smartform for every line.

When I do the preview, and press back button, it takes me through the preview of all the items.

Is there a way to come out of this preview.

I am trying to use the cancel button in at user-command, but the program doesnot seem to recognise it.

[Former Member]

Hi,

Regarding your qusetion about the preview.: In case you are calling the smartform inside a loop, the preview is going to get called. Incase you want just the 1st form to be shown, you could hardcode it in the program. Your logic could be:

If its print preview, then exit in the 2nd pass of the internal table by checking the sy-tabix.

Let us know if this suits your need. If it doesnt then throww more light on your question so that we cud suggest better!

[Former Member]

Hi,

Regarding your qusetion about the preview.: In case you are calling the smartform inside a loop, the preview is going to get called. Incase you want just the 1st form to be shown, you could hardcode it in the program. Your logic could be:

If its print preview, then exit in the 2nd pass of the internal table by checking the sy-tabix.

Let us know if this suits your need. If it doesnt then throww more light on your question so that we cud suggest better!

[Former Member]

thanks for your response.

I am using a similar logic.

Within the loop i am reading sy-ucomm and exit if it is SCAN.

That is when users press cancel button then it exits from the loop.