Execution of Program

[Former Member]

Hi all,

I have developed a program and created a transaction code for that program. when i used to execute the program i give the transcation code.. It directs me to the selection screen page.. after making the required changes when i execute it, the selection screen just closes and goes back to SAP initial page.

Whereas if I go and execute the program in SA38 transaction its working fine.

Could anyone tell me what could be the error behind this.

[Former Member]

The screen should be 1000 as Paul mentioned.

Are you doing any check based n the SY-TCODE?

Regards,

Ravi

[Former Member]

Is the trancode set up to execute SCREEN 1000?

Anything in an AT SELECTION-SCREEN that is getting out of the program if there is an error?

Anything in an AT SELECTION-SCREEN OUTPUT that is getting out of the program if there is an error?

[Former Member]

Deleted dbl post.

Edited by: Paul Chapman on Jun 5, 2008 10:42 AM

[Former Member]

The screen should be 1000 as Paul mentioned.

Are you doing any check based n the SY-TCODE?

Regards,

Ravi