error while testing inbound idoc

[Former Member]

When iam testing inbound idoc in WE19.when i press inbound function module in debugging mode..it gives error like interface to function module is incorrect

kindly give me the answer

regards

shankar

[Former Member]

shankar,

Check in the control record you have passed all the necassary data. I am saying the PORT, PARTNER No., PARTNER TYPE both for sender and recipient. Also pas the message type. After passing all the data in the control record. Press the standard inbound button check the Green button is glowing for Partner profile found. If not there is some error in the settings. Check the settings again and try it.

Regards,

Prakash.

[Former Member]

but in standard inbound it is showing green button

[former_member404244]

Hi Shankar,

check whther u r using the correct function module for correct message type.

anyway check the following configurations for an inbound idoc.

1>we81

2>we31

3>we30

4>bd51

5>we57

6>we42

7>we20

Regards,

Nagaraj

[Former Member]

What message type and function module are you specifying?