Error while loading AR using FB01

[Former Member]

I read and converted the data.

there are no special char for the empty fields as I have made it as space for no data.

after I run the batch input I get the error as

FB012 Session 1 : Special character for 'empty field' is /

FB174 Doc. : Record end indicator in table BBKPF was not supplied with /

FB023 ... Table BBKPF was extended

FB024 ... Before the next put,

FB025 ... also maintain the new fields in table BBKPF

FB174 Doc. 1 : Record end indicator in table BBSEG was not supplied with /

FB023 ... Table BBSEG was extended

FB024 ... Before the next put,

FB025 ... also maintain the new fields in table BBSEG

FB019 Session 1 session name AR_OPEN_ITEM : No terminations have been found

Any idea where to check..?

thanks

[Former Member]

hope ur doing for each field,

This following code you have to write in Mapping step for that particular field. change according to ur structures

if not as91_ztable-anln1 is initial.

BALTD-AIBN1 = AS91_ZTABLE-ANLN1.

else.

baltd-aibn1 = '/'.

endif.

Here: as91_ztable-----> is the source structure.

anln1----

---

> source field.

baltd-----> target structure.

aibn1---->target field.

see if we dont have ne value in the flat file for the particular, we need to pass the / value for that field.

[Former Member]

pass the '/' for every field if the field is initial.

u can do this in mapping step.

[Former Member]

I did.

same errors is encountering.

[Former Member]

hope ur doing for each field,

This following code you have to write in Mapping step for that particular field. change according to ur structures

if not as91_ztable-anln1 is initial.

BALTD-AIBN1 = AS91_ZTABLE-ANLN1.

else.

baltd-aibn1 = '/'.

endif.

Here: as91_ztable-----> is the source structure.

anln1----

---

> source field.

baltd-----> target structure.

aibn1---->target field.

see if we dont have ne value in the flat file for the particular, we need to pass the / value for that field.

[Former Member]

Now it says..

Unable to interpret "/" as a number.(as a abap dump)

[Former Member]

hope ur doing in the mapping step writing the code for every field am i rite

[Former Member]

There are like more then 200 fields..

should I do it for only one field..?

[Former Member]

if u dont know h many fields are empty in the flat file then u have to write the code for all the fields.

if u know which fields are empty in the flat file then u have to write above code which i have posted for that particular field only.

[Former Member]

Use the BAPI - 'BAPI_ACC_DOCUMENT_POST'

Rgds,

A.I.Rajesh.