Dynamic selection screen

[Former Member]

Dear all,

i m writing code in se38.

i want a selection screen which contain one input screen, ex-

Material Number

on based upon material number i want to show some radio button on screen.

i want to display radio buttons based on material number.

suppose i material = 1.

then, Radio Button 1

Radio Button 2

If Material = 2

Then,

Radio Button 1

Radio Button 2

Radio Button 3

Radio Button 4

Plz Help me how can i set this functionality in program

Anshuman

[Former Member]

Dear all,

i m writing code in se38.

i want a selection screen which contain one input screen, ex-

Material Number

on based upon material number i want to show some radio button on screen.

i want to display radio buttons based on material number.

suppose i material = 1.

then, Radio Button 1

Radio Button 2

If Material = 2

Then,

Radio Button 1

Radio Button 2

Radio Button 3

Radio Button 4

Plz Help me how can i set this functionality in program

Anshuman

[anup_deshmukh4]

Use AT SELECTION SCREEN OUTPUT event and then place radio buttions in group and using SCREEN internal table do what erver you want ...!

Hope it helps

[Former Member]

Hi Anshuman ,

You will have to use Flow logic of screen. In PBO call one module say CHECK . In that Module you write the code as follows :

1. Create a screen with radio buttons 1,2,3,4.

2. MODULE CHECK OUTPUT.

if material = 1.

loop at screen.

IF screen-name = 'radio button 3'.

screen-invisible = 1.

MODIFY SCREEN.

ENDIF.

IF screen-name = 'radio button 4'.

screen-invisible = 1.

MODIFY SCREEN.

ENDIF.

endloop.

endif.

Hope this will help you. Please get back to me in case of any confusion.

regards,

Nikhil

[Former Member]

I m writing a ALV report.

where i write these codes, in AT selection screen or some where else?

[anup_deshmukh4]

write in the block of AT SELECTION SCREEN OUTPUT

GOUP YOUR RADIO BUTTONS OR MAKE A FRAME OR MAKE A BLOCK

in the AT SELECTION SCREEN OUTPUT block

LOOP AT SCREEN.

• ( User proper radio button group name and all and also see the screen structre you have fields for visiblity and enebeling - dusabkubg )

modify screen.

ENDLOOP.

[Former Member]

Hi Anshuman,

You need to write the logic at AT SELECTION-SCREEN OUTPUT.

TRY this code.

PARAMETERS: p_matnr(8) TYPE c.

PARAMETER: r_b1 TYPE c RADIOBUTTON GROUP g1,

r_b2 TYPE c RADIOBUTTON GROUP g1,

r_b3 TYPE c RADIOBUTTON GROUP g1,

r_b4 TYPE c RADIOBUTTON GROUP g1.

AT SELECTION-SCREEN OUTPUT.

IF p_matnr EQ '1'.

LOOP AT SCREEN.

IF screen-name EQ 'R_B3'.

screen-active = '0'.

ENDIF.

IF screen-name EQ 'R_B4'.

screen-active = '0'.

ENDIF.

MODIFY SCREEN.

ENDLOOP.

ELSE.

LOOP AT SCREEN.

screen-active = '1'.

MODIFY SCREEN.

ENDLOOP.

ENDIF.

START-OF-SELECTION.

[Former Member]

Thanx a lot Ravindra,

My Problem is Solved.

this code is exactly the solution which i want.

Thanx once again.

Anshuman

[anup_deshmukh4]

yep ...Raveendra Sunagar .has given you a better code...!

Cheers...!