dynamic Internal Table synatax Problem

[Former Member]

Hi Experts.

I am creating the Dynamic Internal table by using the method:cl_alv_table_create=>create_dynamic_table.

we are using the 4.6 version.

it is showing an error that 'Statemant cl_alv_table_create=>create_dynamic_table ( is not defined, Please check your spelling.

but the same thing , working in ecc 6.0.

Thanks in advance,

Regards,

[Former Member]

Hi,

Check whether the class cl_alv_table_create exists in SE24 in 4.6 version.

I suppose in 4.6 version this class does not exists.

So you cannot use it.

Regards,

Ankur Parab

[Former Member]

Hi,

Check whether the class cl_alv_table_create exists in SE24 in 4.6 version.

I suppose in 4.6 version this class does not exists.

So you cannot use it.

Regards,

Ankur Parab

[uwe_schieferstein]

Hello

Most likely there is just a problem with the writing of the method call:

DATA:
  lt_fcat    TYPE lvc_t_fcat,
  ldo_itab  TYPE REF TO data.

"... fill fieldcatalog
CALL METHOD cl_alv_table_create=>create_dynamic_table
  IMPORTING
    it_fieldcatalog = lt_fcat
  EXPORTING
   ep_table          = ldo_itab.

This coding should be syntactically correct. Perhaps you just need to add the following statement to your report (at the beginning):

CLASS cl_alv_table_create DEFINITION LOAD.

On 4.6c the system is not always able to do this itself. You need to explicitly make the class known.

Regards

Uwe