DriverProgram is not getting triggered when PO is created or changed?

[Former Member]

Hi all,

I have one peculiar problem.In nace transaction for output type (NEU) both my printprogram(zprogram) and form(zform) and form routine(entry_neu) was configured.

Now my requirement is to add some additonal data to the purchaseorder form(zform).So I am trying to add that in the form

'entry_neu' of the driver program(zform).Actually that driver program contains 3 more includes and is a subroutine pool program.In one include form routine(entry_neu) was defined.I put a breakpoint there and created/changed the PO .But this driverprogram(zform) and form routine(entry_neu) are not getting triggered.But I am getting PO in SPO1 transaction.But in nace transaction both these zform and entry_neu have been configured .

What might be the reason.Remember zform is a copy of standard program 'SAPFM06P'.

My purpose is to add some additional data to the PO.

Please its very very urgent.

Thanks,

Krishna

[Former Member]

Hi all,

I have one peculiar problem.In nace transaction for output type (NEU) both my printprogram(zprogram) and form(zform) and form routine(entry_neu) was configured.

Now my requirement is to add some additonal data to the purchaseorder form(zform).So I am trying to add that in the form

'entry_neu' of the driver program(zform).Actually that driver program contains 3 more includes and is a subroutine pool program.In one include form routine(entry_neu) was defined.I put a breakpoint there and created/changed the PO .But this driverprogram(zform) and form routine(entry_neu) are not getting triggered.But I am getting PO in SPO1 transaction.But in nace transaction both these zform and entry_neu have been configured .

What might be the reason.Remember zform is a copy of standard program 'SAPFM06P'.

My purpose is to add some additional data to the PO.

Please its very very urgent.

Thanks,

Krishna

[Former Member]

Hi,

Can you please answer the belwo question for me:

In SP01 what form out put you are getting ??? the new modifird form or the standard form output without your custom fields???

If the standard form is the one you are getting in the spool request then your configuration is not reflected in the transaction point of view. If this is your case check the configuration once again.

Thanks,

Greetson

[RaymondGiuseppi]

Look through this thread

Regards