debug

[Former Member]

how to debug module pool program?

[Former Member]

how to debug module pool program?

[Former Member]

Hi,

Put a dynamic break point in PBO and debug it.

Or put /H in command propmt it will activate the debugger now enter your transaction code of the modulepool program.

Award points if useful else getback,

aleem.

[Former Member]

Hi,

write a statement like.

BREAK-POINT.in the beginning of that module pool program and call that transaction code.then u can debug.

rgds,

bharat.

[Former Member]

Hi,

You put Break-point in PBO screen and PAI screen, then give your T-code in

command prompt. otherwise you give /H in command prompt.

WORKFLOW OF SCREEN.

1. Initially the screen will move PBO-->Screen

loop at screen.

Screen> PAI>PBO-->Screen.

endloop.

IF HELPFULL GIVE REWARDED POINTS

[Former Member]

Hi,

U can debug like same as the report program....

se80..give a name for ur program..

See after your code activate the code and put a break point where u need it..Then u right click the program name and give activate in new window..It will take u as per the code flow..

You want to activate the prgram and run via debugging from the start of ur code means..Rightr click ur p[gm name and click execute via debuging..

REWARD IF USEFUL

[Former Member]

Hi panduranga,

Suppose u eant to debug the F150 t-code related program. Open the program related to F150 and set break point. Then execute F150 and type /H in command box. Now based on your perfomr it will enter into debug mode.

Hope this helps you. Reply for queries, shall post the updates.

Regards.

Kumar.

[jaideeps]

hi,

put a breakpoint code at your flow logic...or

go for /h command in ur prompt...

check out with our latest debugger and you have many options..

thankx

jaideep

reward points if it is useful...