Debug technique - how to?

[Former Member]

Hi,

I would like to stop processing for debug in a function module, called in a way:

CALL FUNCTION 'My_Function_Module_Name' STARTING NEW TASK '0001'.

Is it possible? If yes - How?

Explanations: Calling FM

...CALL FUNCTION 'ENQUEUE_E_TRDIR'...

from my FM 'My_Function_Module_Name' I achieved starting of only 1 instance of my FM 'My_Function_Module_Name' at a time. If I call it without the addition 'STARTING NEW TASK...' everything behaves as expected, but I'm unable to check if the FM will behave correctly if I call it as expected - with mentioned addition.

Correctly means if there will be only 1 instance at a time.

Any help whould be highly appreciated.

Many thanks in advance.

Regadrs,

Ivaylo Mutafchiev

[Former Member]

Sorry Again.....I didn't noticed that...Wl take care in future....I am surprised how it came into the current threads....

[Former Member]

Well, searching the forum sometimes gives the answer or idea

Ok, I think I found the scenario - it is to use entire power of parallel processing:

CALL .. STARTING NEW TASK PERFORMING someTaskInCaller ON END OF TASK

should do the trick and help me check what's going on in my 'parallel' task.

And I think, it's impossible to debug task started in parallel process, isn't it?

Thanks,

Ivaylo

[Former Member]

Hi Ivaylo,

You can debug a function module being processed parallelly using system debugging. Set a breakpoint at the function call (the one using STARTING NEW TASK) and then switch on system debugging in the debug mode.

[Former Member]

This Might help you:

http://help.sap.com/saphelp_47x200/helpdata/en/c6/617cbee68c11d2b2ab080009b43351/content.htm

[Former Member]

>

> This Might help you:

No Not At All!!!

See the actual Date Of question.It been Close to 4 years before.

[Former Member]

Sorry Again.....I didn't noticed that...Wl take care in future....I am surprised how it came into the current threads....