configure idoc

[Former Member]

hello everyone

im new to idoc configuration, i was trying a test case for an idoc to be used in the same system

1) i created 2 logical systems - SAP800 and SAP801

2)Assign client to sender system

3)Create RFC destination

4)Create distribution model

5)Distribute model by adding the message type MATMAS for sender SAP800 and receiver SAP801

But when Im generating partner profile, Im getting an error "No messages have been defined for the selection conditions in the model"

Can anybody help me in that plz

[Former Member]

hello everyone

im new to idoc configuration, i was trying a test case for an idoc to be used in the same system

1) i created 2 logical systems - SAP800 and SAP801

2)Assign client to sender system

3)Create RFC destination

4)Create distribution model

5)Distribute model by adding the message type MATMAS for sender SAP800 and receiver SAP801

But when Im generating partner profile, Im getting an error "No messages have been defined for the selection conditions in the model"

Can anybody help me in that plz

[Former Member]

Hi,

After creating the LSs , u can assign LS to sender and then go to receiver create LS and assign to receiver.

after that create RFC destination and maintan the settings correctly.

Then go to BD64 create model and give nmessage type in message type row, and then give proper sender and receiver LSs and excute.

Then go to generate PF manually.

[Former Member]

Hi,

Mention the message type in tcode BD64 - distribution model..

Regards,

Sushmitha

Edited by: Sushmitha S on Mar 6, 2008 5:22 PM