2008 Jun 04 3:36 AM
Hi guys,
I have this data below for my itab:
type numc type c type c type p
90001 cca cca 1000
90002 cca cca 2000
cca cca 1000
90002 cca cca 3000
cca cca 2000
then i collect here: collect itab.
my new data for itab is this:
90002 cca cca 5000
My expected output should be :
cca cca 3000
why is it that when the first entry is blank, the collect seem not to work...?
thanks!
rgds,
mark
2008 Jun 04 9:22 AM
i think u hv to close this thread or u hv any probelm just post.
Hey,
U can use like wise............
LOOP AT ITAB.
AT END OF...........
SUM <FLD3>
WRITE.............
ENDAT
ENDLOOP.
Try yhis out. it will help u
Reward all helpful answers,
Thanks
2008 Jun 04 3:48 AM
go throuth code , i did same wht u want , at the end see output. its coming correct only.
run this code.
data: begin of it_out occurs 0,
a type n,
b(3) type c,
c(3) type c,
d type p,
end of it_out.
it_out-a = 90001.
it_out-b = 'cca'.
it_out-c = 'cca'.
it_out-d = 1000.
collect it_out.
it_out-a = 90002.
it_out-d = 2000.
clear it_out.
it_out-a = 9002.
it_out-d = 3000.
loop at it_out.
write:/ it_out-a, it_out-b, it_out-c , it_out-d.
endloop.
2008 Jun 04 4:59 AM
Bluesky
