BDC scrolling problem

[Former Member]

HI ,

I am facing problem while recording for Txn PO13.

I have to enter an infotype by scrolling but not possible.

Any ideas ??

Thanks,

Sandip.

[guillaume-hrc]

Is this using a Table Control ?

Are you sure you cannot access it through an index ?

(Which leaves the problem of finding the index by the way...)

[RichHeilman]

It is a table control, but there is no "position to" or anything like that which would allow you to go to a certain infotype.

Regards,

Rich Heilman

[Washington]

Hi Sandip,

i don't know if it will work in a BDC session, but i tried online and it works, clique in the table control, write P+ in the command and press ENTER.

[Former Member]

Hi Washington,

P+ does not work.I used Txn PP02 instead of PO13.

Thanks,

Sandip.

Ph: +44 121 683 2814.

[guillaume-hrc]

When I meant 'index', I wanted to say like this :

SAPMH5A0 5100

=> MARKFELD(<b>01</b>) = X

Is not this possible ?

[Former Member]

I have tried this one also,but ultimately I have to opt for another transaction.

Thanks anyway.

[Former Member]

I don't think this transaction is a good candidate for BDC. Have you explored other possibilities like a fuction module or a BAPI or a standard SAp program?

Srinivas