Community
Application Development and Automation Discussions
Join the discussions or start your own on all things application development, including tools and APIs, programming models, and keeping your skills sharp.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
Read only

BDC-MM02

Former Member

‎2007 Jan 03 11:32 AM

0 Likes
571

Hi Experts,

Im wirting a BDC for MM02. There is a problem that the number of views maintained in Materials Master are not same. So in recording, the view marked for selection does not correspond to the view when opening MM02 for some material.

Please suggest how to tackle this when there is invariable number of views in material master, i want to make changes to views using BDC.

For example - i want to update Basic Data1 and MRP1 view in MM02. For some material there can be three views between above two views and for some material there might be six views between the two. im not able to determine the position of view to mark for selection at run time. Also the screen name and number is same for these views. This the BDC is not running properly..

Please suggest??

abap-raj

Hi Experts,

Im wirting a BDC for MM02. There is a problem that the number of views maintained in Materials Master are not same. So in recording, the view marked for selection does not correspond to the view when opening MM02 for some material.

Please suggest how to tackle this when there is invariable number of views in material master, i want to make changes to views using BDC.

For example - i want to update Basic Data1 and MRP1 view in MM02. For some material there can be three views between above two views and for some material there might be six views between the two. im not able to determine the position of view to mark for selection at run time. Also the screen name and number is same for these views. This the BDC is not running properly..

Please suggest??

abap-raj

Reply
4 REPLIES 4
Read only

Former Member

‎2007 Jan 03 11:33 AM

0 Likes
545

Hi,

I posted the sol in your other thread Rajiv . did u have a look.

santhosh

Read only

Former Member
In response to Former Member

‎2007 Jan 03 11:45 AM

0 Likes
545

Dear Santosh,

The solution of yours is useful, but again i dont no how much OK codes to use in BDC, because the number of views between the views i want to update keep on changing from material to materia.. For example in some materials the Sales View is maintained and fro some material sales view is not maintained. I want only Basic Data1, MRP1, MRP2 and MRP3 views to be updated

Read only

Former Member
In response to Former Member

‎2007 Jan 03 11:55 AM

0 Likes
545

ya, that is true,

U need to keep track of what you are having for example as u said sales view u would know that you have sales related data then u trigger the OK_CODE of sales tab..as of OK_CODE try to determine what all are possible and required....Well, hope that helps...any how I wish you would find a better way tgh...which ofcourse I would like to know...too

santhosh

Read only

Former Member
In response to Former Member

‎2007 Jan 03 12:25 PM

0 Likes
545

Use a BAPI/IDOC instead. Far less pain in the long run.