Batch input session

[Former Member]

HI Gurus!

i want to run a cycle through bdc - VA01 - VL01N - VF01 .

once the user will fill details for VA01 then bdc will generate order [VA01 ] ,then delivery[VL01N] and invoicing [ VF01 ].

so to run multiple Transactions in a bdc we have use call session?

Do in call session , i can record this cycle of multiple transactions?

Plzz help me ! urgent!

Rahul

[Former Member]

Hi,

You are absolutely wright.

USE:

Call Transaction C_Va01 Using T_Bdcdata

Mode w_mode

• Mode C_N

Update C_Sync

Messages Into T_Messtab.

*

refresh t_bdcdata.

Clear: w_vbeln, w_sales_order.

DESCRIBE TABLE t_messtab LINES w_no_of_lines_of_messtab.

LOOP AT t_messtab FROM w_no_of_lines_of_messtab

WHERE ( msgid = 'V1' )

• AND ( msgnr = '260' )

AND ( msgnr = '261' )

AND ( tcode = 'VA01' )

AND ( dyname = 'SAPMV45A' )

AND ( dynumb = '4001' )

AND ( msgtyp = 'S' ).

*Delivery is not created @ this point in time

• w_vbeln = t_messtab-msgv3.

w_sales_order = t_messtab-msgv2.

Endloop.

*

From the above you will get the order no so wait for a while by using CALL FUNCTION 'ENQUE_SLEEP'

EXPORTING

SECONDS = 10

to ensure that all databases have been updated & then proceed with CALL Transaction of VL01N etc etc....

Regards

Raju Chitale

[Former Member]

Hi Raju!

there is no way in batch input session where we can records a cycle of multiple t-codes.

regards,

Rahul

[Former Member]

Hi,

You need to have three different recordings one each for VA01, VL01N & VF01. Once you are theu with VA01 updation use the FM ENQUE_SLEEP to wait for a while & then get the order no by looping at the 'Messages' trapped in CALL TRANSACTION of VA01. Use that order no & fire CALL TRANSACTION for VL01N. Again wait a while by using the above mentioned FM & pick up the delivery no ( again by looping at the messages received from cALL TRAN ) & again CALL TRANSACTION For VF01 by using the delivery no obtained above.

I hope this clarifies the matter.

Regads

Raju Chitale