Community
Application Development and Automation Discussions
Join the discussions or start your own on all things application development, including tools and APIs, programming models, and keeping your skills sharp.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
Read only

Batch input (mm01) through a job

Former Member

‎2006 Dec 07 9:45 PM

0 Likes
357

Hi,

I have a problem with a batch input on MM01.

I want to extend material for a new center and I do it through a batch input. If I execute this batch input with F8 and in mode = 'N', it ends ok.

The problem is when I run this program with a job, the material is not added to the new center.

Can anyone help me?

Thanks,

Liliana.

Hi,

I have a problem with a batch input on MM01.

I want to extend material for a new center and I do it through a batch input. If I execute this batch input with F8 and in mode = 'N', it ends ok.

The problem is when I run this program with a job, the material is not added to the new center.

Can anyone help me?

Thanks,

Liliana.

Reply
1 REPLY 1
Read only

marilyn_pratt
Active Contributor

‎2006 Dec 07 10:11 PM

0 Likes
323

Do we have a forum for you.

It's called the Data Transfer forum. You can find it under ABAP Category.

There is a good likelihood of getting Batch Input (Data Transfer Method) questions answered there.

Go to and when in doubt use the forum search. You might already have an answer to your question sitting out there.

Marilyn