Authorization object

[Former Member]

Hi,

My requirement is to create a authorization object such that user having this Auth Object attached to his profile can change a value of field on particular Tcode from X to y.

Please explain the different steps i need to carry out.

I tried with few steps but aftaer that i have no idea how to proceed.

1> I created a object class in SU21

2> Then i created one authorization object under this class.

3> I went to SU20 to create field name for which i want to restrict these values.

4 > Now back to SU21 i selected that field.

Afer that i am not sure wht other steps i need to carry out.....where i will assign possible values such that person can only set value.

[Former Member]

Hi Sanju

It seems that procedures were correct. However is important to check authorization check statment in your programs

AUTHORITY-CHECK OBJECT <my_objc> 
         ID 'ACTVT' FIELD 'X'
         ID 'myfield' FIELD 'myvalue'

   IF sy-subrc NE 0.
      User does not have access to this record/area 
   ENDIF

Kind regards

Edited by: Carlos Machado on Jun 3, 2010 2:13 AM

[former_member214857]

Hi Sanju

It seems that procedures were correct. However is important to check authorization check statment in your programs

AUTHORITY-CHECK OBJECT <my_objc> 
         ID 'ACTVT' FIELD 'X'
         ID 'myfield' FIELD 'myvalue'

   IF sy-subrc NE 0.
      User does not have access to this record/area 
   ENDIF

Kind regards

Edited by: Carlos Machado on Jun 3, 2010 2:13 AM

[Former Member]

Hi Sanju,

Please read the following:

The ABAP syntax of the AUTHORITY-CHECK statement is:

AUTHORITY-CHECK OBJECT '<object>' (which created by you in SU21)

ID '<name1>' FIELD <f1> (fields given in Authorisation object)

u2026u2026u2026u2026u2026u2026u2026u2026u2026u2026u2026

ID '<name10>' FIELD <f10>.

Where <object> is the name of the authorization object that has to be

checked, <name1>,..., <name10> are the authorization fields in the object,

and <f1>,... ,<f10> are the values for which the authorization is to be

checked. If after the field name is entered DUMMY, the check for a

particular field will not be carried out.

FYI

AUTHORITY-CHECK statement first checks if the user has the authorization

containing all the required values. Then the code value in the system field

SY-SUBRC is checked. If the required value is available for each

authorization field, the check is successful (SY-SUBRC = 0). If the value is

not 0, then the check is unsuccessful, which means that the user does not

possess the required authorization and an error message will be displayed.

AUTHORITY-CHECK sets SY-SUBRC to 4, 8, 12, 16, 24, 28, 32 or 36 depending on

the cause of the authorization failure, e.g. return code 4 means that the

user does not have the required authorization; SY-SUBRC = 8 means that the

check could not successfully be carried out since not all fields of the

object were specified.

May this helps you.

Regards.

Deepak Sharma.