ASAP:Debugging

[Former Member]

Have written some coding in the user exit how to debug it?

[Former Member]

Put a break point in your exit.

Run the transaction that will trigger your exit.

Thanks,

Victor.

[Former Member]

go into the code and write break-point in it.

[Former Member]

Hi,

Place a static break-point in that exit.Then run the transaction.It will start the debugger when the exit gets fired.

[Former Member]

Hi Saranya,

Never ever use break-point in general, always be specific when you want to debug a exit. Use the following syntax :

BREAK <USERID>

Hope this is helpful to you. If you need further information, revert back.

Reward all the helpful answers.

Regards

Nagaraj T

[Former Member]

Hi,

write static breakpoint using BREAK USERID avoid using BREAK-POINT that might cause some problems.

Then execute ur transaction.

Rgds.,

subash

[Former Member]

Write BREAK USERID or BREAK-POINT at the first line of the include program.

[Former Member]

saranya srithar,

Write STOP where you want to debug.

than run the t-code it will trigger and stop at here.

Amit.

[Former Member]

check this link