Application Document Not Posted

[dhruv_shah3]

Hi All,

I am generating through the standard message type MATMAS.

Now i am sending the material from Client A to Client B through BD10.

I am successfully able to send the material. Now i am receiving the material

in CLient B through BD11. which is successfully recieved.

But when i check the IDOC in Client B through we02 i am getting following Error:

1) Application Document not posted in MATMAS.

2) Error in ALE service: Could not determine recipients for message type MATFET.

So please help me out asap.

Regards,

Dhruv Shah

[Former Member]

Issue might be Partner profile..

Please check in WE20 Transaction ,look at Inbound parameters ,see the process code..

Material master process code should be MATM.

Please change to MATM ,Save it.

Now goto BD10 ,Send the material again and see the results.

Thanks

Seshu

[Former Member]

there is problem in Inbound settings of reciever partner..

Please see in WE20 on recieving partner.

Regards.

[varma_narayana]

Hi Dhruv..

First of all you no need to use the BD11 Tcode in Receiving system.

Just create the Partner profile in Receiving system for Message type MATMAS with PROCESS CODE as MATM.

Now when you Run BD10 in the Sending system the IDOC will be posted in the Receiving system directly.

<b>Reward if Helpful.</b>

[dhruv_shah3]

Thanks for your reply.

I have followed the steps you mentioned, but then also i am getting the same error

and also of MATFET.

For MATFET i have given process code MATF. then also i am getting this error.

Regards,

Dhruv Shah