ale/idoc setting

[Former Member]

Please use more informative subjects in future. How are we supposed to differentiate between your questions when you keep using the same subject?

hi

i created a distribution model and when i am distributing it i am getting the following message

"RFC destination for synchronous communication (message type SYNCH

Partner profile LS 800 SYNCH does not exist

Generate partner profile

or specify outbound partner profiles for message type SYNCH"

what should i do ...i maintained synch message type in outbound parameteres of partner profile..

can someone tell me what i need to do?

Edited by: Matt on Mar 23, 2009 2:14 PM

[Former Member]

hi

when i am generating partner profile the following mesage is displayed...

"No messages have been defined for the selection conditions in the model"

[Former Member]

hi,

Check for the following.

Was the RFC destination maintained through TCODE SM59.

Were the logical systems created and assigned. ??

And also check for the inbound settings too.

Regards

Sharath

[Former Member]

Hi,

First of all generate the partner profile in BD64 by following path.

Environment ->Generate Partner Profiles.

Thanks,

Asit Purbey.

Edited by: Asit Purbey on Mar 23, 2009 11:25 AM

[Former Member]

hi

when i am generating partner profile the following mesage is displayed...

"No messages have been defined for the selection conditions in the model"

[Former Member]

Hi,

Either configure all partner profiles in WE20 and then the distribution model in BD64 and distribute the model view or, set up the distribution model with the required message types along with SYNCH message type and generate partner profiles from BD64.

~ Bineah.

[Former Member]

Hi,

Check your Outbound and inbound patner profile are set up correctly or not. Check in distribution model Sender system, receiver system and message type has been maintained correctly.

Thanks,

Asit Purbey.

Edited by: Asit Purbey on Mar 23, 2009 12:20 PM

[Former Member]

hi,

Check all the steps one bye one . Are u can Add message type SYNCH in sending as outbound and in Recieving as inbound .

let me know if any queries.

~linganna

[matt]

Please use more informative subjects in future. How are we supposed to differentiate between your questions when you keep using the same subject?

[Former Member]

thanks alot