Adding data to internal table

[Former Member]

Hi,

Does any one can tell, is it possible to add a new line into an internal table while debugging a program ?

Robert

[Former Member]

Hi,

Does any one can tell, is it possible to add a new line into an internal table while debugging a program ?

Robert

[Former Member]

Hi,

Yes you can add any no. of lines while debugging.

There is a button in the debugging mode "Append".

Message was edited by: Phani Kiran Nudurupati

[Former Member]

Yes it is possible.

Just click on the Insert/Append tab.

But U should have authorization to change the Internal

table in debugging mode.

[Former Member]

Hi Robert ,

You can do that.While debugging atthe bottom of the screen you can find a append/add button --Press that and add entries.

Lanka

[Former Member]

Under Tables column

Internal Table Name:

Use <b>insert</b> button to enter new line

[manuel_bassani]

Hi Robert,

sure you can.

1. go in table visualization mode clicking "Tables" in the upper section of debug screen

2. write internal table name and press enter

3. You can insert a line between two others by positioning the cursor on a line and choosing Insert

4. You can append a line as the last row by clicking Append

5. Write data inside the line and press ENTER or double click the line to insert data field by field

Regards, Manuel

[Former Member]

HI.

Yes. Its possible.

INSERT line. while debugging.

Thanks,

Maheshwari.V