- SAP Managed Tags
Above approaches will work for a popup screen and not for the information message you may be talking about.
If you are talking about the information/error message you receive, there is no easy way to reach the source code.
1. Note the mesage number, go to SE91 and do a where used.
But again, this may not work always, since a message may be populated dynamically and it wont be traced in where used.
2. You need some patience for this. Whenever you run a transaction, just before the step you get error, start a debugger with /H.
Then navigate to below screen, and give command 'Message'.
You might come across some irrelevant messages, but you will succeed in time.
Bluesky
- SAP Managed Tags
Above approaches will work for a popup screen and not for the information message you may be talking about.
If you are talking about the information/error message you receive, there is no easy way to reach the source code.
1. Note the mesage number, go to SE91 and do a where used.
But again, this may not work always, since a message may be populated dynamically and it wont be traced in where used.
2. You need some patience for this. Whenever you run a transaction, just before the step you get error, start a debugger with /H.
Then navigate to below screen, and give command 'Message'.
You might come across some irrelevant messages, but you will succeed in time.
| User | Count |
|---|---|
| 3 | |
| 1 | |
| 1 | |
| 1 | |
| 1 | |
| 1 | |
| 1 | |
| 1 | |
| 1 | |
| 1 |
